Hope this helps and again, sorry for the late reply. This has to be the first board I have seen that doesn't have multiple UART ports on it and that doesn't have a 3.3 pad. ![]() Always double check all settings after saving. Tried it, but it gets stuck on 'Searching for Flight Controllers.'. so yeah, that would be too easy, wouldnt it. I may have those backwards and if I do, it will turn off the serial rx when you save the file. Installing the latest CP210x Drivers, rebooting - nothing changed. Unless the SID for SBUS is UART3 or something, the RX6 is going to be your only option.įrom there you will need to go into the config tab and set a serial rx to on, then you will need to go into the receiver tab and set it to spektrum 2048. I'm only seeing one Rx port and that is where the GPS is wired into in your picture. VCC and ground are pretty self explanatory but the signal (usually gray wire, maybe yellow) needs to go to an RX port on the board. I always use a 3.3 port, but it seems this board doesn't have one and taught me something today! I didn't know they could go up to 9v!), ground and then you have the signal. With a Spektrum Sat, you will need the VCC (5v in this case. The Impulse RC Driver Fixer usually works pretty daing good Free Driver Scout is a holistic driver software that injects life into your PC and eliminates things that could potentially slow down your system 5mm) RGB LED is designed to be surface-mount soldered and is the most compact way possible to integrate multiple bright LEDs to a design 0. ![]() I have been studying that FC trying to find where to wire everything up to and this one surprises me.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |